Culligan CULLIGAN-IC-MB Manuel d'instructions télécharger pdf (Page 2)

Performance Data



Read this performance data and compare the capabilities of this system with your

actual water treatment needs. It is recommended that, before installing a water

treatmentsystem,youhaveyourwatersupplytestedtodetermineyouractual

water treatment needs.

ThissystemhasbeentestedbyWQAaccordingtoNSF/ANSIStandard42for

reduction of the substances listed below. The concentration of the indicated

substances in water entering the system was reduced to a concentration of less

thanorequaltothepermissiblelimitforwaterleavingthesystem,asspecified

inNSF/ANSIstandard42.

Test Conditions

Flow Rate = 0.50 gpm (1.9 L/min)

Inlet Pressure = 60 psi (4.14 bar)

pH = 7.5 ± 1

Temperature = 68°F +/- 5°F (20°C +/- 2.5°C)

Operating Requirements

Pressure: = 30 - 100 psi (2.07-8.62 bar)

Temperature = 40 - 100°F (4.4 - 37.7°C)

 Turbidity =5NTUMax.







International: Phone (847) 430-1239 • Fax (920) 457-7366

e-mail: [email protected]



Rosemont, Illinois 60018

www.culligan.com

Substance InfluentChallenge Max.PermissibleProduct Reduction Minimum Average

Concentration Water Concentration Requirements Reduction Reduction

Standard 42

Chlorine 2.0 mg/L±10% 2.0 mg/L±20% ≥50 76.7% 85.1%

Flow Rate=0.50 gpm (1.9 L/min) Capacity=2,500 gallons (9464 L) or 12 months

Testingwasperformedunderstandardlaboratoryconditions,actualperformancemayvary.

QUESTIONS? Call Technical Support: 1-800-721-9243, Mon.-Fri., 8:00 AM-4:30 PM CST

IOWARESIDENTSONLY:

Store or seller’s name

Address

City State Zip

Telephone

Seller’s signature

Customer’s signature Date

TheIC-100AisTestedandCertifiedbyWQAagainstNSF/ANSI42Standardforreductionof

aestheticChorineTasteandOdorandNSF/ANSIstandard372forlowleadcompliance.

Do not use with water that is microbiologically unsafe or of unknown quality without

adequate disinfection before or after the system.

1 2 3 4

Commentaires sur ces manuels

Pas de commentaire

Culligan CULLIGAN-IC-MB Manuel d'instructions Page 2

Commentaires sur ces manuels