Culligan 2 Manuel d'utilisateur télécharger pdf (Page 10)

Before you call for service . . .

If you unexpectedly experience hard water, make these simple checks before

calling your Culligan Man. One of the following conditions may be the reason

for your interruption of service.

IMPORTANT:

If any of the following conditions are found, the water conditioner should be

manually recharged according to instructions on page 7 after you have

corrected the condition.

POWER SUPPLY

Check your power supply cord. Is it plugged fully

into the electric outlet? Be certain that the outlet

does not have a wall switch which has been turned

off. Reset conditioner to proper time of day and

then plug in.

BLOWN FUSE

Check the house fuse or circuit breaker panel.

Replace a blown-out fuse or reset an open circuit

breaker.

POWER FAILURE

Any interruption in your power supply, or time

changes — such as daylight savings — will disrupt

your conditioner’s recharge schedule by causing

the timer to run off schedule. Reset timer to proper

time of day.

SALT SUPPLY

Check it. Refill if necessary and wait approximately

four hours for the salt to dissolve before initiating a

recharge cycle.

BY-PASS VALVES

Check to see if they are in the proper position.

Cul-Flo-Valv

by-pass, if used, should be in the “Push

for Soft Water” position. If hand valves are used,

see that inlet and outlet valves are opened and

that the bypass valve is closed.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15

Pas de commentaire

Culligan 2 Manuel d'utilisateur Page 10